Matrox Iris GT MIL, Installation And Technical Reference, Page: 34 / 256

34 Chapter 3: Configuring your Matrox Iris GT to work on a network
Configuring your Matrox Iris GT to work with
a network that uses DHCP
To configure your Matrox Iris GT so that it will obtain an IP address automatically
(that is, use DHCP), use the Matrox IrisBootParams utility, and perform the
following:
1. Disconnect your Matrox Iris GT 100/1000 BaseT cable from your network.
2. Connect your Matrox Iris GT 100/1000 BaseT cable directly to your computer.
3. On your computer, launch the Matrox IrisBootParams utility. To do so, from the
Matrox Imaging submenu of the Windows Start menu, select Iris series . From
the presented submenu, select Matrox Iris GT utilities , and then click on
IrisBootParams.
❖
Note that the Matrox Iris GT utilities must be installed on your computer. If they
are not, refer to
Chapter 6: Installing application development software .
The Matrox IrisBootParams utility opens.