iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual
Issue 2.3
400
Table 4.4.5.28-1 SYSTEM TIMERS
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Flex DID Timer
The system will receive DID digits for this timer.
After the timer expires, the system will use the last 2 to 4 digits
received as DID digits.
01~99
(100 msec)
10
R2 Out Manage
Timer
Reserved for future usage for R2 timers.
01~50
(seconds)
14
R2 In Manage
Timer
Reserved for future usage for R2 timers.
01~50
(seconds)
14
R2 Disappear
Timer
Reserved for future usage for R2 timers.
01~50
(seconds)
14
R2 Pulse Timer
Reserved for future usage for R2 timers.
01~30
(*20ms)
7
R2 Ready Timer Reserved for future usage for R2 timers.
000~500
(*200ms)
7
Dial Tone Delay
Timer
Reserved for future usage for R2 timers.
01~30
(*20ms)
20
Wake Up Fail
Timer
At expiration of this timer, the system will notify the Attendant
when a user does not respond to a Wake up alarm.
00~99
20
VSF Cut Error
Tone Timer
The duration of Voice Messages in the built-in Voice Mail are
reduced by this timer to remove error tone that may be sent by
the carrier after disconnect.
00~90
(seconds)
0
On Hook Auto
Idle Timer
When an iPECS IP or LDP Phone receives a disconnect
message or signal from CO line the phones goes to idle after
this timer.
00~99
(seconds)
0
IP Watch Timer
When Local redundancy is implemented, should the LAN cable
fail, both call servers may attempt to be active. To protect
against this “dual active” case, the system can periodically check
for an active back-up module.
0~250
(1 sec.)
0
Prepaid Call
Drop Warning
Timer
When the Prepaid funds are exhausted, the user will receive a
warning tone indicating the call will be dropped after this timer
expires.
00-99
10
Emergency retry
timer
System try to make emergency call according to the CO access
rule/Prefer CO/CO group if system could not seize predefined
emergency Co line within this timer.
00~99
(seconds)
0
Record Warning
Repeat Timer
If record warning tone is set and this timer is set greater than 1,
it works periodically when it’s recorded.
000~999
(seconds)
0
Error Tone Timer This timer sets the duration for Error Tone.
5~180
(seconds)
30
Howling Tone
Timer
This timer sets the duration for Howling Tone.
0~180
(seconds)
30
VM Notify Play
Delay Over CO
Timer
When VM notification to the mobile uses an analog loop start
Line, system will treat the call as the answered after this timer
and play the new message prompt.
1~99
(1 sec.)
10
