iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual
Issue 2.3
334
4.4.4.11 CID/CPN Attributes - PGM 151
Selecting CID/CPN Attributes will display the CID/CPN Attributes data input page.Enter a valid CO range and
click
[Load]
to enter the CID/CPN Attributes data.Use the check mark to indicate which attributes to modify;
data for checked attributes is stored by clicking
[Save]
button.
Enter CO Range: eMG80/100: 1-74 / eMG800: 1-600 / UCP: 1-998
Figure 4.4.4.11-1 CID/CPN Attributes
COLP: Connected Line Presentation
CLIP: Calling Line Identification Presentation
Setting CID Password directly
You can set the CID password to click “Go to Setting” button. After clicking it, you will move to the following
PGM 162 and set the CID password, and then save CID password to mark tick on the save box and click the
Save button.
Refer to Table 4.4.4.11-1 for information on individual attributes.
Table 4.4.4.11-1 CID/CPN ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
COLP Table
Index
When an incoming call on an ISDN Line is answered, the system
will send caller id using the number from the CLIP/COLP Table
(section 4.4.7.2) entry defined by this parameter. The station
number is included as a suffix of the caller id. For “Using Station’s
COLP Attribute”, the Station CLI type entered below will be used
in place of the station number.
N/A
0-49
Station CLI
N/A
CLIP Table
Index
When a call is placed on an ISDN Line, the system will send caller
id using the number from the CLIP/COLP Table entry defined by
this parameter. The station number is included as a suffix of the
caller id. For “Using Station’s CLIP Attribute”, the Station CLI Type
entered below will be used in place of the station number.
N/A
0-49
Station CLI
N/A