iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual
Issue 2.3
321
4.4.4.2
Analog Attributes - PGM 141
Selecting Analog Attributes will display the Analog Attributes data input page.
Enter a valid CO range and click
[Load]
to enter the Analog (PSTN) Attributes data.
Use the check mark to indicate which attributes to modify; data for checked attributes is stored by clicking
[Save]
button.
Enter CO Range: eMG80/100: 1-74 / eMG800: 1-600 / UCP: 1-998
Figure 4.4.4.2-1 Analog Attributes
Analog Attributes define various characteristics of AnalogCO Lines under control of the system.
Most characteristics require an On/Off setting; refer to the following table.
Specific descriptions for CO Line (SMDR) Call Metering tones are provided in the second following table.
Table 4.4.4.2-1 Analog ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
CO Line Signal
Each analog CO Line can be assigned to send either DTMF or
Pulses for dialed digits to the PSTN.
DTMF
Pulse
DTMF
Data(Fax) Station
Number
Each CO line can be assigned to recognize a FAX call when a
specified station answers.
Station
Number
SMDR Metering
Unit
This field selects the call-metering signal from the PSTN to
indicate call cost, refer to the following table.
None
Line Drop (CPT)
Each CO Line can be programmed to disconnect if error tone
is detected.
OFF
ON
OFF
Maintain CPT on
talking (Answer by
User)
The system can continuously monitor the CO Line during a call
and, if error tone is detected, drop the call.
OFF
ON
OFF
