Leica 14051454200, Instructions For Use Manual

Page: 90 / 164

90
Version 2.1, Revision K
Daily Instrument Setup
6
The colored handles of the racks must be attached corresponding to the previously defined parameter set
color ( → P. 67 – 5.9.2 Assigning a parameter set to a rack handle color) .
The slide handles are available in 9 colors (8 parameter set colors & white) (
→
P. 153 – 9.1 Optional
accessories) .
Note
Special function of the white handle:
• The white handle cannot be permanently assigned to a parameter set. Corresponding to a "wildcard
function", the white handle has to be reassigned to a parameter set each time the program is used.
For this purpose, a selection menu opens on the screen automatically after inserting the rack.
Proceed as follows to attach or replace the rack handles:
Detach the handle from the rack.
1. Slightly pull the handle apart (
→
Fig. 69- 1 ) so that the handle wire can be pulled out of the hole
in the holder.
Attach a handle to the rack.
» Lightly pull the handle apart so that the handle wire can snap into the respective holes in the
holder.
Note
• Be sure that the handle is correctly positioned in the upper position, centered above the rack
( → Fig. 69)
• For stable placement when filling, fold the handle to the side as far as it goes (
→
Fig. 69- 2 ) so that
it can be used as an additional protection to prevent tipping.
1
1
2
Fig. 69