InfiniSource ETC 100, Hardware Manual

Page: 194 / 234

182 Infinisource
4. Locate the three bell wires. One is the ground wire, one is the
power source positive wire, and one is the power source negative
wire.
5. Connect the power source ground wire to the ground terminal on
the bell.
6. Connect the power source negative wire to the negative terminal on
the bell.
7. Connect the power source positive wire to the positive terminal on
the bell.
8. Measure an appropriate distance down the power source positive
wire from the bell and cut the wire (the distance between the bell
and the place where you cut the wire determines how far the bell
can be from the clock).
Make sure you cut only the positive wire .
9. Strip 1/4 inch of insulation from each of the two positive wire ends
created in step 8 and insert each exposed wire into the appropriate
holes in the relay connector. See Figure HARDWARE-6.
Note: The relay on an IQ 1000 clock contains 3 holes. See the fol-
lowing figure and steps in order to determine into which of the 3
holes you should insert the 2 ends of the wire.