TimeForce II Hardware Guide
123
Velocity Clocks
Enrolling Finger ID Templates
Before your employees will be able to enter punches at the V800, their
finger IDs must first be enrolled at the clock.
1.
Press the <MENU> button on the time clock keypad. Select 1 for
“Admin.” The following message appears:
ENTER YOUR CARD #
2.
Enter the card number of a user that has access to the “Admin”
clock features and press the <ENTER> key on the clock keypad.
Note:
The default administrator username is “8888.” The following
message appears:
ENTER PIN:
3.
Enter the password for the given card number and press the
<ENTER> key on the clock keypad.
Note:
The default administrator password is “1111.”
4.
The main menu appears with several options. Press 2 for “Manage
Finger IDs.”
5.
Press 1 for “New Finger ID.”
6.
The prompt ENTER CARD NUMBER appears. Enter the card
number or keypad entry number that you assigned to this employee
in the TimeForce software and press <ENTER>.
7.
A prompt appears that reads:
CARD # XXXX:YY
FIRST OF 2 SCANS
PUT FINGER
ON SENSOR
Note:
“XXXX” denotes the employee’s card number. “YY”
denotes the number of templates already stored in the clock for the
displayed card number.
8.
Have the employee whom you are enrolling place his or her finger
in the template reader. Usually the index finger is used, though the
middle and ring fingers can also produce good results. To ensure
correct placement, the employee should place the first joint of the
finger against the raised ridge at the base of the reader screen, and
place the fingertip firmly against the screen.
Summary of Contents for ETC 100
