InfiniSource ETC 100, Hardware Manual

Page: 193 / 234

TimeForce II Hardware Guide 181
Installing a Bell/Buzzer
IQ 1000 Time Clock
1. Remove the clock from the wall (if it has already been mounted),
turn it over and examine the back. At the bottom of the clock case a
panel is cut out, revealing the hardware components on the inside of
the clock. The clock relays are located in the lower left-hand corner
of the cutout section. See Figure HARDWARE-5.
Figure HARDWARE-5: IQ 1000 Motherboard
2. The motherboard on an IQ 1000 clock contains two relays. One is
used with the “Bell/Buzzer” feature, the other is used with the
“Door Security” feature. The bell/buzzer relay is the first visible
component on the left-hand side of the cutout section of the clock
case.
3. Lay the clock on a flat, secure surface with the electronic compo-
nents facing up.
NOTE: Make sure that the electrical wires are not live. Serious
injury or death can result from coming in contact with live electri-
cal wires.