InfiniSource ETC 100, Hardware Manual

Page: 207 / 234

TimeForce II Hardware Guide 195
Finger Enrollment Station
Finger Enrollment Station
The Finger Enrollment Station is used to enroll and store the finger tem-
plates of your employees from a computer workstation, instead of hav-
ing to perform new enrollments at a time clock.
Finger templates are stored in the TimeForce database. The ClockLink
utility can then be used to upload the stored templates to your time
clocks.
The following instructions walk you through installing, setting up and
using the Finger Enrollment Station.
Hardware Installation
Use the following instructions to connect your Enrollment Station to a
computer. The Enrollment Station must be installed on the same
machine as the utility that connects to the unit. This machine must also
have access to the TimeForce program database.
Two cords extend from the base of the Enrollment Station. One is the
power cable, the other is a serial cable.
• Locate the power cable and plug it into the closest available electri-
cal (110-120 VAC) outlet.
• Locate the serial cable (with standard 9-pin connector) and connect
it to an available serial port on your computer.
Note: The Enrollment Station can also be connected to a USB port
using a Keyspan USB to serial adapter.
Before you can begin using your Enrollment Station, you must first
install the utility that the station works with.