InfiniSource ETC 100, Hardware Manual

Page: 80 / 234

68 Infinisource
7. The Finger ID menu appears with the following options:
1. NEW FINGER ID
2. CHECK EXISTING
3. DELETE EXISTING
4. GLOBAL SECURITY
Press 1 to enter finger templates for the first time.
8. The prompt ENTER CARD NUMBER appears. Enter the card
number or keypad entry number that you assigned to this employee
in the TimeForce software and press <ENTER>.
9. A prompt appears that reads:
READING FINGER ID
PUT FINGER
ON SENSOR
10. Have the employee whom you are enrolling place his or her finger
in the IQ 1000 fingerprint reader. Usually the index finger is used,
though the middle and ring fingers can also produce good results.
To ensure correct placement, the employee should place the first
joint of the finger against the raised ridge at the base of the reader
screen, and place the fingertip firmly against the screen.
11. Once the clock has read the fingerprint, the following message
appears:
QUALITY: [X]/100
CONTENT: [X]/100
OK TO ACCEPT?
YES NO
This message denotes the general quality of the fingerprint read.
You want both the “QUALITY” and “CONTENT” numbers to be
as high as possible. Press the grey button under “YES” to accept the
fingerprint read. Press the button below “NO” to have the clock
read the fingerprint again.