TimeForce II Hardware Guide
37
Using the Model IQ 300, 400 or 500 IntelliClock
3.
Quickly and evenly slide the card through the card reader slot from
top to bottom.
Note:
Proximity time card users need only hold their time card up
to the target located on the right of the face of the clock.
4.
The display panel shows the card number of the card just swiped,
and reads:
MAKE SELECTIONS
THEN PRESS “ENTER”
5.
Press the <DEPT> key. The following is displayed:
CARD: X OVERRIDE
DEPT:
6.
A punch type of “override” is selected by default. Note that the
<DEPT> key is a toggle. Press it again to switch to a punch type of
“transfer.”
Once you have specified the punch type, enter the desired department
number and press <ENTER>.
IQ 400 Clock
The following instructions walk you through entering data at a model IQ
400 IntelliClock. The IQ 400 tracks basic time & attendance informa-
tion, as well as job, task and quantity tracking.
Time & Attendance Punches
Use the following instructions to enter basic time and attendance
punches at the clock (with no job, task or department information).
1.
Check to see if the display panel on the clock reads “READY.” If
the word “READY” is not visible, refer to “Clock Communication
Troubleshooting” on page 169 of this guide.
2.
If you are using magnetic time cards, hold the card with the mag-
netic strip facing right. If you are using cards with barcodes, hold
the card with the barcode facing left.
3.
Quickly and evenly slide the card through the card reader slot from
top to bottom.
Note:
Proximity time card users need only hold their time card up
to the target located on the right of the face of the clock.
Summary of Contents for ETC 100
