InfiniSource ETC 100, Hardware Manual

Page: 83 / 234

TimeForce II Hardware Guide 71
Using the Model IQ 1000 IntelliClock
Setting the Global Security Level
In addition to an individual security level that is set for each employee,
the IQ 1000 also has a global security setting. By default, this is set to
level 5, the highest level of security. When an employee is clocking in,
the clock checks the global setting and the individual setting and uses
the lower of the two. If you wish to, you may change the global security
setting as well, though this is not recommended.
1. Press the <MENU> button on the keypad, select the “ADMIN”
menu option, and enter your card number and password.
2. Press # 1 for SYSTEM MAINT.
3. Press # 4 for FINGER ID.
4. Press # 4 for GLOBAL SECURITY. The following message
appears:
CURRENT SECURITY
LEVEL IS: 3
1=MINIMUM, 5=MAXIMUM
NEW SECURITY:
The default global security level is 5. Type in the new security level and
press the <ENTER> key.
Collecting Data
Punching in and out is very simple with the IQ 1000. Within the Time-
Force software, each employee is assigned a “Card Number.” This num-
ber corresponds with either a magnetic swipe card, a proximity time
card, a barcode card, or a number the employee enters at the clock’s
keypad. If the IQ 1000 is ready to accept punches, the word “Ready”
appears in the display panel.
Note: Employees may enter their card number using the keypad rather
than swiping a card if the Direct Keypad Entry option is enabled on your
IQ 1000.
Time & Attendance Punches
Use the following instructions to enter basic time and attendance
punches at the clock (with no job, task or department information).