TimeForce II Hardware Guide
177
Installing a Bell/Buzzer
7.
Measure an appropriate distance down the power source positive
wire from the bell and cut the wire (the distance between the bell
and the place where you cut the positive wire determines how far
the bell can be from the clock).
IMPORTANT:
Make sure you cut ONLY the positive wire.
8.
Use a pencil or similar instrument to punch out the pre-scored hole
in the back panel of the clock case.
9.
Strip 1/4 inch of insulation from each of the two positive wire ends
created in step 7 and thread both of them through the hole in the
back of the clock.
10. Insert one exposed wire into each of the two holes on the relay con-
nector.
11. Tighten both screws to secure the wires.
Replacing the Motherboard
1.
Carefully replace the motherboard into the clock case. Ensure that
the indicator lights and connectors line up with the slots and holes
in the case.
2.
Screw the motherboard into place.
3.
Plug the card reader and keypad cables (if so equipped) into their
respective connectors.
4.
Replace the back panel and screw it into place. The wires from the
relay connection extend from the holes in the back panel.
5.
Attach the clock and bell to the wall in their respective locations.
6.
Connect the clock and bell to their power sources and reconnect the
clock’s communication cable.
Note:
In order to use your bell/buzzer, you must first set up “Relay
Events.” Consult the section of this guide pertaining to your clock type
for further instructions on setting up and using Relay Events.
Summary of Contents for ETC 100
