TimeForce II Hardware Guide
41
Using the Model IQ 300, 400 or 500 IntelliClock
6.
Enter the desired job either by typing the job number at the keypad
and pressing <ENTER>, or by scanning it in using an optional bar-
code reader or wand. The following message appears:
QTY, TASK, or ENTER
7.
If you are finished entering punch information, press the <ENTER>
key to save the punch entry. Press the <TASK> key to enter task
information, or the <QTY> key to enter a quantity.
8.
Press the <TASK> key to specify a task with the punch. Enter the
desired task number at the keypad, or scan it using a barcode wand
or reader, and press <ENTER>. The following message appears:
QTY or ENTER
9.
If you are finished entering punch information, press the <ENTER>
key to save the punch entry. If you would like to specify a quantity
with this punch, press the <QTY> button.
Note:
The <QTY> button can be pressed at any point during the
punch entry process.
10. Enter the desired quantity. By default, a decimal is assumed at two
places. For example, an entry of “1500” would appear as “15.00”
when downloaded.
Note:
Assumed decimal places can be configured from the Clock-
Link utility.
11. Press the <ENTER> key to save the punch.
Note:
Time clock entry procedures can vary depending on the settings
specified in the TimeForce software. Refer to the “Job Settings” section
of the TimeForce Job Tracking guide for information on the available
job tracking settings.
Department Entries
Use the following instructions to enter punches at the time clock that are
assigned to a specific department level.
There are two different types of department entries, “Department Over-
rides” and “Department Transfers.”
Summary of Contents for ETC 100
