186
Infinisource
Before You Install the Reader
The external reader should be mounted in the correct location before
connecting it to the time clock. Mount at shoulder-height if cards are
normally worn around the neck on a lanyard. Mount at hip-height if
cards are activated “hands-free” by bringing the hip containing the card
holder (i.e., wallet) close to the reader.
The wires from the reader must be long enough to reach from the reader
to the clock. The wires may be extended up to 100 feet total length,
although you must be cautious to ensure that longer wire runs are routed
away from electrical noise sources such as power lines, motors, flores-
cent lights, etc.
Installing the Reader
The following instructions will walk you through connecting your exter-
nal door security reader to the time clock.
Note:
Power should be removed from the clock before connecting the
reader wires.
1.
Remove the clock from the wall (if it has already been mounted),
turn it over and examine the back. At the bottom of the clock case a
panel is cut out, revealing the hardware components on the inside of
the clock. The Wiegand connector is located directly to the right of
the RJ11 (telephone-type) “WAND” connector. See Figure HARD-
WARE-7.
Summary of Contents for ETC 100
