InfiniSource ETC 100, Hardware Manual

Page: 87 / 234

TimeForce II Hardware Guide 75
Using the Model IQ 1000 IntelliClock
• Task List: To select the desired task from a list of tasks that have
been uploaded to the time clock, press either one of the grey
buttons located above the number pad on the clock keypad.
Use the up and down arrow buttons to scroll though the avail-
able tasks. Once the desired task in the list is highlighted, press
<ENTER> on the clock keypad.
Note: The task list contains the task profiles from the Time-
Force software that you have uploaded to the IQ 1000 using the
ClockLink utility.
11. The following message appears on the clock:
JOB, TASK OR QTY
ENTER = FINISHED
12. If you are finished entering punch information, press the <ENTER>
key to save the punch entry. If you would like to specify a quantity
with this punch, press the <QTY> button.
Note: The <QTY> button can be pressed at any point during the
punch entry process.
13. Enter the desired quantity (remember to use the period key), and
press <ENTER> to save the punch.
Note: Time clock entry procedures can vary depending on the settings
specified in the TimeForce software. Refer to the “Job Settings” section
of the TimeForce Job Tracking guide for information on the available
job tracking settings.
Department Entries
Use the following instructions to enter punches at the time clock that are
assigned to a specific department level.
There are two different types of department entries, “Department Over-
rides” and “Department Transfers.”
1. Check to see that the clock display is showing the logo screen with
the time displayed at the bottom.
2. If you are using cards with magnetic strips, hold the card with the
magnetic strip facing right. If you are using cards with barcodes,
hold the card with the barcode facing left.