TimeForce II Hardware Guide
73
Using the Model IQ 1000 IntelliClock
Job Tracking Entries
Use the following instructions to enter punches at the time clock which
are assigned to job and task information in the TimeForce system.
1.
Check to see that the clock display is showing the logo screen with
the time displayed at the bottom.
2.
If you are using cards with magnetic strips, hold the card with the
magnetic strip facing right. If you are using cards with barcodes,
hold the card with the barcode facing left.
3.
Quickly and evenly slide the card through the card reader slot from
top to bottom. If you are using direct keypad entry, type the card
number into the clock keypad and press <ENTER>. The display
panel shows the card number and reads:
READING FINGERPRINT
PUT FINGER
ON SENSOR
Note:
The Biometric unit on an IQ 1000 is optional. Finger tem-
plate steps do not apply to a clock with no Biometric unit.
4.
Place your finger on the IQ 1000 fingerprint reader. To ensure cor-
rect placement, the employee should place the first joint of the fin-
ger against the raised ridge at the base of the reader screen, and
place the fingertip firmly against the screen. Once your fingerprint
has been verified, the following message is displayed:
CHOOSE:
DEPT
JOBS IN/OUT
TIPS LUNCH/BREAK
**ENTER** TO ACCEPT
Note:
The available options on this screen depend on which fea-
tures are enabled on your clock. For instance, if you do not have the
“IN/OUT” keys enabled, then the option for IN/OUT will not
appear on this screen.
5.
Press the <JOB> key on the time clock keypad. The following mes-
sage is displayed:
Summary of Contents for ETC 100
