InfiniSource ETC 100, Hardware Manual

Page: 190 / 234

178 Infinisource
IQ Clocks
The procedures for connecting your bell or buzzer to an IQ clock vary
slightly depending on whether you are using an IQ 300/400/500 model
clock, or an IQ 1000 model clock. Follow the instructions that corre-
spond to your clock model.
IQ 300, 400 or 500 Time Clock
1. Remove the clock from the wall (if it has already been mounted),
turn it over and examine the back. At the bottom of the clock case a
panel is cut out, revealing hardware components on the inside of the
clock. The relay is locted in the lower left-hand corner of the cutout
section. See Figure HARDWARE-3.
Figure HARDWARE-3: IQ 300, 400 or 500 Motherboard
2. Lay the clock on a flat, secure surface with the electronic compo-
nents facing up.