IBM Netfinity 3500 M10, User Handbook Manual

Page: 75 / 268

Setting automatic power-on features
The Automatic Power-On features within the Power Management
menu allow you to enable and disable features that automatically
turn your server on. You must also select the startup sequence you
want to use for the type of power-on event selected. If you select
Automatic
, make sure Automatic Power On Startup Sequence in
the Startup Sequence menu is set to enabled. Otherwise, the system
will use the Primary startup sequence.
Ÿ
Wake on LAN: If you have remote-network-management
software, you can use the IBM-developed Wake on LAN feature
built into the integrated Ethernet subsystem in your server.
(You can also use the Wake on LAN feature if you have
disabled the integrated Ethernet subsystem and have installed a
properly configured token-ring adapter that is enabled for Wake
on LAN.) When you set Wake on LAN to Enabled, your server
will turn on when it receives a specific signal from another
computer on your local area network (LAN).
Ÿ
Wake Up on Alarm: With this feature, you can specify a date
and time at which the server will be turned on automatically.
This can be either a single event, a daily event, or a weekly
event.
Ÿ
PCI Wake Up: If enabled, this setting allows your system to
power on in response to wake up requests from PCI devices
that support this feature.
To set Automatic Power-On features:
1. Start the Configuration/Setup Utility program (see “Starting and
using the program” on page 19).
2. Select Power Management from the Configuration/Setup Utility
program menu.
3. Select Automatic Power On.
4. Select the menu item for the feature you want to set. Use Left
Arrow (
←
) or Right Arrow (
→
) to select either Enabled or
Disabled.
5. Select Startup Sequence for the feature. Use Left Arrow (
←
) or
Right Arrow (
→
) to select either Primary or Automatic.
Chapter 3. Configuration/Setup Utility program
57