IBM Netfinity 3500 M10, User Handbook Manual

Page: 151 / 268

Setting the diskette write-protect switch
The diskette write-protect switch controls whether you can write
information to a diskette using a diskette drive. The ability to
prevent writing to a diskette is particularly useful if you are
concerned about the security of information that can be obtained
through a network.
Note: This switch does not affect the ability to read information
from a diskette.
Before you begin
Ÿ
Read “Safety information” on page 70 and “Handling
static-sensitive devices” on page 72.
Ÿ
Turn off the server and all other connected devices.
Ÿ
Disconnect all external cables attached to the server, and
then remove the server cover (see “Preparing to install and
remove options” on page 75).
1. Locate the rocker switches on the system board. Refer to the
label inside the server or see “Identifying parts on the system
board” on page 82.
2. For normal diskette operation or for read-only diskette
operation, set switch 8 as illustrated below. It might be helpful
to use the end of a small screwdriver to set the switch.
Normal Diskette Operation
1 2 3 4 5 6 7 8
ON
OFF
Read-Only Diskette Operation
1 2 3 4 5 6 7 8
ON
OFF
What to do next:
Ÿ
To work with another option, go to the appropriate section.
Ÿ
To complete the installation, go to “Completing the installation”
on page 134.
Chapter 5. Installing options
133