IBM Netfinity 3500 M10, User Handbook Manual

Page: 159 / 268

Configuring an ISA legacy adapter
To configure an installed ISA legacy adapter, you might need to
alter switch or jumper settings on the adapter. Also, you must use
the Configuration/Setup Utility program to identify the ISA legacy
resource requirements, such as memory locations, I/O assignments,
and DMA and interrupt assignments.
Note: For more information about required resources and switch
settings, refer to the documentation that comes with the
adapter.
To store the legacy resource information for an installed adapter:
1. Start the Configuration/Setup Utility (see “Starting the
Configuration/Setup Utility program” on page 137).
2. Select ISA Legacy Resources from the Configuration/Setup
Utility menu and press Enter.
3. As needed, select Memory Resources, I/O Port Resources,
DMA Resources, or Interrupt Resources.
4. Set the appropriate resource to ISA Resource and press Enter.
5. Remember to save the changes when you exit from the
Configuration/Setup Utility program.
6. Return to the Configuration/Setup Utility menu and select Save
Settings to save the changes. From this location, you can exit
the Configuration/Setup Utility program.
To exit from the Configuration/Setup Utility program, follow
these steps:
a. From the Configuration/Setup Utility menu, press Esc.
b. The Exit Setup menu appears. You can save your changes,
exit from the Configuration/Setup Utility program without
saving your changes, or return to the Configuration/Setup
Utility menu. Use the arrow keys to select the desired
option and press Enter.
Chapter 5. Installing options
141