IBM Netfinity 3500 M10, User Handbook Manual

Page: 156 / 268

To access the Configuration/Setup Utility program:
1. Turn on the server.
If your server is on when you start this procedure, you must
shut down the operating system, turn off the server and wait a
few seconds, and then restart the server. Do not use
Ctrl+Alt+Del
to restart the server.
2. When the Configuration/Setup Utility prompt appears in the
lower left corner of the screen, press F1.
a. If you have not set an administrator password, the
Configuration/Setup Utility program menu appears. If you
have set an administrator password, type the administrator
password and press Enter.
b. If you have set both an administrator and a power-on
password, you can type either of the passwords at the
password prompt. However, if you type your power-on
password, you can view limited information in the
Configuration/Setup Utility program, but you cannot change
settings. To change settings in the Configuration/Setup
Utility program, type your administrator password at the
password prompt.
138
Netfinity 3500 M10 User's Handbook