IBM Netfinity 3500 M10, User Handbook Manual

Page: 214 / 268

1. If necessary, remove the adapters installed in the option slots.
For instructions, see “Removing adapters” on page 107.
2. If necessary, disconnect any cables from the system board that
might impede access to the battery.
3. Read “Lithium battery notice” on page ix.
4. Remove the old battery as shown in the following illustrations.
5. Install the new battery as shown in the following illustrations.
Note: When the server is turned on for the first time after
battery replacement, an error message might be
displayed. This is normal after replacing the battery.
What to do next:
Ÿ
To work with another option, go to the appropriate section.
Ÿ
To complete the replacement, go to “Completing the
installation” on page 134.
Ÿ
Use the Configuration/Setup Utility program to set the date and
time and any passwords. For information on setting the date
and time, refer to “Setting the date and time” on page 42. For
information on setting passwords, see “Setting passwords” on
page 143.
Ÿ
Dispose of the old battery as required by local ordinances or
regulations.
196
Netfinity 3500 M10 User's Handbook