IBM Netfinity 3500 M10, User Handbook Manual

Page: 37 / 268

Starting and using the program
To start the Configuration/Setup Utility program:
1. Turn on your server. If your server is already on when you
start this procedure, you must shut down the operating system,
turn off the server, wait a few seconds until all in-use lights go
off, and restart the server. (Do not use Ctrl+Alt+Del to restart
the server.)
2. When the Configuration/Setup Utility program prompt appears
in the lower left corner of the screen during startup, press F1.
(The Configuration/Setup Utility program prompt appears on
the screen for only a few seconds. You must press F1 quickly.)
3. If you have not set an administrator password, the
Configuration/Setup Utility program menu appears on the
screen. If you have set an administrator password, the
Configuration/Setup Utility program menu will not appear until
you type your administrator password at the password prompt
and press Enter. See “Understanding the power-on password”
on page 42 and “Understanding the administrator password”
on page 47 for more information.
Chapter 3. Configuration/Setup Utility program
19