IBM Netfinity 3500 M10, User Handbook Manual

Page: 132 / 268

4. If necessary, use the SCSISelect utility program to change
settings for the integrated SCSI controller.
Note: To locate connectors on the system board, see “Identifying
parts on the system board” on page 82.
The following are some important points to remember when
connecting power and signal cables to internal drives:
Ÿ
The diskette drive, hard disk drive, and CD-ROM drive that are
preinstalled in your server come with power and signal cables
attached. If you replace any drives, it is important to remember
which cable is attached to which drive.
Ÿ
When you install a drive, ensure that the drive connector at the
end of the signal cable is always connected to a drive; also,
ensure that the drive connector at the other end is connected to
the system board. This reduces electronic noise from the server.
Ÿ
If two IDE devices are used on a single cable, one must be
designated as the primary or master device and the other a
secondary or subordinate device; otherwise, some of the IDE
devices might not be recognized by the system. The primary or
secondary designation is determined by switch or jumper
settings on each IDE device.
For help in selecting drives, cables, and other options for your
server, do one of the following:
Ÿ
Within the United States, call 1-800-IBM-2YOU (1-800-426-2968),
your IBM reseller, or your IBM marketing representative.
Ÿ
Within Canada, call 1-800-565-3344 or 1-800-465-7999.
Ÿ
Outside the United States and Canada, contact your IBM reseller
or IBM marketing representative.
114
Netfinity 3500 M10 User's Handbook