IBM Netfinity 3500 M10, User Handbook Manual

Page: 185 / 268

POST
message
Description
1802 A PCI adapter has requested an I/O address that is not available, or the PCI
adapter might be defective.
Action:
1. Make sure that all ISA legacy adapters are set correctly in the
Configuration/Setup Utility program. If the I/O address settings are not
correct, change and save the settings. Setting the resources used by ISA
legacy adapters to ISA Resource enables the Plug and Play function to
configure around the legacy adapters.
For background information on PCI, ISA, Plug and Play, and legacy
(non-Plug and Play) adapters, refer to Chapter 5, “Installing options” on
page 67. For information about required I/O resource settings for ISA
legacy adapters, refer to the documentation that comes with these adapters.
For instructions on using the Configuration/Setup Utility program, see
Chapter 3, “Using the Configuration/Setup Utility Program” on page 17.
2. Make sure that switches on all ISA legacy adapters are set correctly. For
information about switch settings, refer to the documentation that comes
with the ISA legacy adapters.
3. If all I/O addresses are being used by ISA legacy adapters, you might need
to remove an ISA legacy adapter to make an I/O address available to the
PCI adapter you want to install. For instructions on removing adapters, see
Chapter 5, “Installing options” on page 67.
Note: If you remove an ISA legacy adapter, set the I/O address used by
the removed adapter to Available before installing another adapter.
4. If you have other PCI or Plug and Play adapters installed, you might need
to remove one of these adapters to make an I/O address available to the
PCI adapter you want to install.
If the problem cannot be isolated and corrected, have the computer serviced.
Chapter 6. Solving problems
167