IBM Netfinity 3500 M10, User Handbook Manual

Page: 45 / 268

Devices and I/O Ports
If you select Devices and I/O Ports from the Configuration/Setup
Utility main menu, you can view and, in some cases, change device
or port settings.
Note: The specific device options might vary, depending on the
computer model.
You can change port assignments or disable ports if you want to
prevent unauthorized transmission of data to any devices attached
to the ports.
Devices and I/O Ports Descriptions
Mouse You must select whether the mouse is installed or not in this
field.
Diskette Drive A If a drive is installed, this field shows the diskette storage
capacity of the drive. If you change or add a diskette drive,
you might need to use this option to set the correct type.
Diskette Drive B If a drive is installed, this field shows the diskette storage
capacity of the drive. If you change or add a diskette drive,
you might need to use this option to set the correct type.
Serial Port Setup
Serial Port A Address
Serial Port A IRQ
Serial Port B Address
Serial Port B IRQ
The Serial Port Setup menu shows the addresses and interrupts
for the built-in serial ports.
If you add adapter cards with serial ports, an error message
will notify you if you have an address conflict among the serial
ports. Ensure that each serial port has a different address. If
you change serial port addresses in this menu, you might also
need to make changes in the software that uses serial ports.
For instructions on changing your software, see the user's guide
or online information that comes with the software.
USB Setup
USB Support
USB Keyboard/Mouse
Support
The USB Setup menu presents options to enable or disable the
Universal Serial Bus feature.
Select Autodetect for USB Keyboard/Mouse Support if you
want this support to be enabled when a USB keyboard or a
USB mouse is detected after the computer is started. Select
Disabled if you will not be using a USB keyboard or USB
mouse.
Chapter 3. Configuration/Setup Utility program
27