IBM i 830, Repair Manual

Page: 686 / 1000

5. Perform the following:
a. Select System Service Tools (SST). If you cannot get to SST, select DST.
Do not perform a system IPL to get to DST.
b. Select the Start a Service Tool option.
c. Select the Hardware Service Manager option.
d. Select Device Concurrent Maintenance and enter the required information in
the information fields. Do not press the Enter key at this time.
e.
Read the remaining steps of this procedure and ensure that you understand
the procedure before continuing.
f. Press the Enter key on the console. After the delay time, the light at the top
right of the device will begin flashing. You now have 9 seconds to pull out
firmly on the handles and pull the unit partially out of the tower.
Attention: If you remove the device when the light is not flashing, data
may be lost, the unit may be damaged, or the backplane may be damaged.
Note: The light at the top right of the device will go off and remain off as
soon as the device is no longer making contact with the backplane.
g.
Remove the unit from the tower.
v
If you need to remove a tape from the old tape unit, see “Tape Cartridge
– Manual Removal” on page 701.
v
If you need to remove a CD-ROM or DVD media, go to “Optical Media –
Manual Removal” on page 704, and then continue with the next step of
this procedure.
This ends the removal procedure. Continue with the next step of this
procedure to install the new unit.
6. Perform the following to install a new unit:
a. Select Device Concurrent Maintenance and enter the required information in
the information fields. Do not press the Enter key at this time.
b.
Read the remaining steps of this procedure and ensure that you understand
the procedure before continuing.
c. Slide the unit partially into the tower. Ensure that the device does not
contact the backplane at this time.
d. Press the Enter key on the console. After the delay time, the light at the top
right of the device will begin flashing. You now have 9 seconds to push in
firmly on the handles and push the unit completely into the frame.
Attention: If you install the device when the light is not flashing, data
may be lost, the unit may be damaged, or the backplane may be damaged.
Note: The light at the top right of the device will go off and remain off for
a few seconds when the device contacts the backplane. Then it
should go on and remain on.
Figure 21. Internal removable media locations
Remove and Replace Procedures
672
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1