IBM i 830, Repair Manual

Page: 185 / 1000

Reference Code Description/Action Perform all actions before exchanging Failing Items Failing Item
9500 I/O processor Licensed Internal Code error
If the system is operational, take a dump of the I/O processor data. For
more information, see the
iSeries Service Functions information or ask your
next level of support for assistance.
FI00130
9800 to 9803 I/O processor successfully recovered from temporary error
No action required. This reference code is logged for information only.
9810 Problem analysis has determined a part should be replaced.
This reference code is used for ending Online Problem Analysis with a list
of failing items. (Information only)
9899 Problem analysis completed, the problem has been corrected.
This reference code is used for ending Online Problem Analysis when no
problem was found or the problem was corrected.
UL2FIXD
9900, FF09 Licensed Internal Code for tape unit was not upgraded
The I/O processor loading of Licensed Internal Code (LIC) to the
programmable tape drive was not completed.
The tape drive will continue to operate with the previous LIC. You may do
either of the following:
v
Wait for next IPL when the system will attempt to load the LIC for the
tape drive again.
v
Perform “TU-PIP4” on page 453 to reset the IOP and the tape drive.
When the IOP is reset, if the device has the wrong level of LIC, the IOP
will attempt to load the new LIC.
UL2WAIT
FF4D I/O processor successfully recovered from temporary error
No action required. This reference code is logged for information only.
When the system is available, display the operator messages, find message
CPI946B, and press F14 to run online problem analysis to see if the error
threshhold has been exceeded.
46G2227
FI00141
FI00830
46G2599
46G3934
17G1500
42F7300
AJEDA00
FF5D I/O processor successfully recovered from temporary error
No action required. This reference code is logged for information only.
When the system is available, display the operator messages, find message
CPI946B, and press F14 to run online problem analysis to see if the error
threshhold has been exceeded.
46G2227
46G3934
FI00830
FI00141
46G2599
17G1500
42F7300
FFF6 Tape volume statistics logged (no action required)
No action required. This reference code is logged for information only.
FFF8 Asynchronous device attached; synchronous device expected
The attached device is operational and working in the asynchronous mode
of data transfer.
The IBM tape unit uses the synchronous mode of data transfer; if the
attached device is an IBM tape unit, exchange the tape unit.
46G2227
7208
Chapter 2. Unit Reference Codes
171