IBM i 830, Repair Manual

Page: 635 / 1000

CAUTION:
The circuit card contains lead solder. To avoid the release of lead (Pb) into the
environment, do not burn. Discard the circuit card as instructed by local
regulations. (RSFTC234)
1. Select System Service Tools (SST) . If you cannot get to SST, select DST.
Attention: Do not perform a system IPL to get to DST.
2. Select Start a Service Tool .
3. Select Hardware Service Manager .
4. Select Packaging hardware resources .
5.
Select Hardware contained within package for the Frame ID that contains the IOA
or IOP that you are removing.
6. Find the card position for the IOA or IOP that you are removing and select
the
Concurrent maintenance option.
7.
A listing of the power domain is shown. Select the Power off domain function
key. Everything within the IOA’s or IOP’s power domain will be powered off .
8. To see the status of the power domain, select the Display power states function
key.
9. Find the IOA or IOP that you are removing and select the Toggle LED blink
off/on option.
10. Remove the cover to access the card that you are removing from the system.
See “FC 5074, FC 5079, FC 9079 – Covers” on page 623.
11. Remove the EMC access plate that is located directly above the card enclosure.
Press the two latching mechanisms together and tilt the top of the cover away
from the frame to remove it.
12.
Look at the power LED (
W
) for the card that you are removing to ensure that it
is powered off. The power LED (
W
) is located to the left and directly above the
card slot. If the LED is blinking multiple times per second (rapidly) or it is off,
then the card is powered off.
13. Disconnect and label any cables from the card that you wish to remove.
14. Turn the blue latch counter clockwise and lift upward on the black latch to
release the card.
15. Gently pull the card off the backplane.
This ends the procedure.
Concurrent Installation Procedure:
All cards are sensitive to electrostatic discharge (see “Appendix C. Working with
Electrostatic Discharge-Sensitive Parts” on page 955).
CAUTION:
The circuit card contains lead solder. To avoid the release of lead (Pb) into the
environment, do not burn. Discard the circuit card as instructed by local
regulations. (RSFTC234)
1. Install the card in to the system by reversing the card removal procedure
above.
2.
Select the Power on domain function key for the IOA or IOP that you are
installing.
Note: To the right of the description field you will see one or both of the
following symbols displayed:
Remove and Replace Procedures
Chapter 4. Removal and Installation Procedures
621