IBM i 830, Repair Manual

Page: 684 / 1000

8. Pull the power distribution backplane slightly towards you and lift it up to
remove it from the frame.
9. Install the power distribution backplane by reversing the removal procedure.
After exchanging an item, go to “Verifying the Repair” on page 920.
This ends the procedure.
Models 830/SB2 with FC 9074 – Power Supply (PP1 and PP2)
1. Do not Power off the system.
Note: Remove and replace only one power supply at a time.
2.
Open the rear cover, see “Models 830/SB2 with FC 9074 – Covers” on page 663.
3. Unplug the power supply cable.
Refer to “Assembly 3: Models 830 and SB2 with FC 9074 – Final Assembly, Rear”
on page 814 and continue with the following steps.
4. Remove the mounting screw from the power supply.
5. Rotate the handle from left to right to release the power supply from the frame.
6. Remove the power supply.
7.
Install the new power supply by reversing the removal procedure.
Note: Do not slam the new power supply when installing it into the system.
Insert the power supply until it engages the frame, then rotate the
Remove and Replace Procedures
670
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1