HP 8568B, Performance Tests And Adjustments Manual, Page: 234 / 313

18. Frequency Control Adjustments
F R E O U E N C Y C O N T R O L
S T A R T
F M S P A N
S T O P
T I L T
Y T O
R E F
R E F
F A S T
Figure 3-71. Location of Frequency Control Adjustments
5. Connect DVM to and ground to
6. Adjust TUNE REF for DVM indication of -10.285
V dc. See Figure 3-71 for location of adjustment.
7.
Key in
[
CENTER FREQUENCY
)
10 MHz,
SPAN
]
0 Hz, Trace
A
[
CLEAR
-
WRITE
),
Sweep Scale LIN.
Start-Up Time
8.
Key in
left
TIME)
Marker Adjust marker to the
edge of the CRT. Key in (SHIFT) then key in (SHIFT)
three times. CRT annotation should indicate SWEEP
GEN measured sweep time.
1 second start-up time:
Note
The start-up time measured in step 8 uses the
function that displays a sweep time value which is 1% to 5%
longer than the actual spectrum analyzer sweeptime. This error is
compensated when using the shift F function to adjust the sweep
times in the following procedure.
9. Key in Marker then
Slow Sweep
10. Key in [SHIFT)
three times and note the CRT
Adjustment
annotation. The annotation should indicate SWEEP GEN
measured sweep time of (1 .OO + start-up time from step 8)
s. To adjust sweep time, adjust SLOW slightly, then
key in
and note new SWEEP GEN measured
sweep time as indicated by CRT annotation. Repeat this process
until the 1 sweep time is within
Note
Adjusting CW decreases the sweeptime.
Adjustments