January 2001
4 - 10
Programming
Service Manual Cafitesse 500
4.1.2.3 Programming Type 460
-
Error readings
----------------------------
-
Counter readings
----------------------------
-
Machine settings
----------------------------
-
Flow settings
----------------------------
-
Settings for
Left button 1
-
Settings for
Left button 2
-
Settings for
Left button 3
-
Settings for
Right button 1
-
Settings for
Right button 2
-
Settings for
Right button 3
-
Settings for
Water button
-
Boiler settings
----------------------------
-
Other settings
----------------------------
-
Clock settings
----------------------------
-
Coin settings
----------------------------
-
Stop programming
----------------------------
●
In the programming mode the dispenser will
return to the stand-by mode when no
button has been actuated for 5 min.
●
To switch off the programming mode,
remove the service device adapter CFT
from the service panel bush.
●
To return immediately to the programming mode:
Switch main switch ON/OFF on the service
panel off and then back on.
●
Select the submenu.
●
Press the
Input
button to enter the sub-
menu or to leave the submenu and to
store the data temporarily.
To program this dispenser a service
device 2 is necessary. It must be a
service device that is equipped with an
E-Eprom V1.4 or higher. The program
version can be checked after pressing
the activating button.
Preparation:
●
Open the cooling compartment lid.
●
Switch the dispenser off at the service
panel.
●
Open the cap of the 9 pole socket (service
panel) for the service device.
●
Connect the service device adapter CFT
(9 pole) to the service device and to the 9
pole socket on the service panel.
●
Press the activating button on the service
device (1) (Fig. 1, pg. 4-8)
Display on the
Service device 2
Service Device:
V1.4 (15-04-88)
(or higher)
●
Switch on the dispenser at the service
panel.
Display on the
Service Panel:
Display on the
Cafitesse V2.20 U
Service Device:
RTD pr=###### I
●
The programming mode is now switched
on.
Press button
↓
or
↑
.
If none of the buttons
↓
or
↑
is pressed within 10 sec. the
programming mode is stopped. The
dispenser goes into stand-by mode.
The following display is shown:
Display on the
Time out
Service Device:
Programming end
●
Select the main menu.
●
Press
↑
and
↓
until the required
menu is shown on the service device.
These are the menus:
