Chapter 6 Fault Code Information and Maintenance
6-4
Fault
Name
Fault Descriptions
Corrective Actions
Ground fault
When (one of) the output terminal(s) is grounded,
short circuit current is more than 50% of AC motor
drive rated current, the AC motor drive power
module may be damaged.
NOTE: The short circuit protection is provided
for AC motor drive protection, not for
protection of the user.
1.
Check whether the IGBT power module is
damaged.
2.
Check for possible poor insulation at the
output line.
Auto accel/decel failure
1.
Check if the motor is suitable for operation by
AC motor drive.
2. Check
if
the
regenerative energy is too large.
3.
Load may have changed suddenly.
Communication Fault
1.
Check the RS485 connection between the AC
motor drive and RS485 master for loose wires
and wiring to correct pins.
2.
Check if the communication protocol, address,
transmission speed, etc. are properly set.
3.
Use the correct checksum calculation.
4.
Please refer to group 9 in the chapter 5 for
detail information.
Software protection failure
Return to the factory.
Analog signal fault
Check the wiring of ACI
PID feedback signal fault
1. Check
parameter
settings (Pr.10.01) and
AVI/ACI wiring.
2. Check
for
possible fault between system
response time and the PID feedback signal
detection time (Pr.10.08)
Phase Loss
Check input phase wiring for loose contacts.
Auto Tuning Fault
1.
Check cabling between drive and motor
2. Retry
again
Communication time-out
fault on the control board
or power board
1.
Press RESET key to set all parameters to
factory setting.
2.
Return to the factory.
Motor overheat protection
1.
Check if the motor is overheat
2.
Check Pr.07.12 to Pr.07.17 settings
PG signal fault
1.
Check the wiring of PG card
2.
Try another PG card
CANopen Guarding Time out
（
Only for VFDxxxExxC
）
Connect to CAN bus again and reset CAN bus
