Dell PowerConnect W-AirWave 7.6, User Manual

Page: 86 / 332

74 | Configuring and Using Device Groups Dell PowerConnect W-AirWave 7.6 | User Guide
Setting Default Description
WPA1 Cipher (Cisco
WLC Only)
TKIP
NOTE:
This drop down is only available if WPA2 WPA Compatibility Mode is
Yes
.
Unicast Cipher
(Cisco Only) AES/TKI-
P
WPA Preshared Key
(Alphanumeric)
None
Encryption Mode xSec
xSec None
3. Select Save to retain these security configurations for the group, select Save and Apply to make the changes
permanent, or select Revert to discard all unapplied changes.
4. Continue with additional security-related procedures in this document for additional RADIUS and SSID settings
for device groups, as required.
Configuring Group SSIDs and VLANs
The Groups > SSIDs configuration page allows you to create and edit SSIDs and VLANs that apply to a device
group. Perform these steps to create or edit VLANs and to set SSIDs.
NOTE: WLANs that are supported from one or more Cisco WLC controllers can be configured on the
Groups > Cisco WLC Config
page.
Figure 42 illustrates an example of the Groups > SSIDs page.
Figure 42:
Groups > SSIDs Page Illustration
NOTE: AirWave reports users by radio and by SSID. Graphs on the AP and controller monitoring pages display bandwidth in and out
based on SSID. AirWave reports can also be run and filtered by SSID. An option on the
AMP Setup > General
page can age out
inactive SSIDs and their associated graphical data.
1. Go to Groups > List and select the group name for which to define SSIDs/VLANs.
2. Select the Groups > SSIDs configuration page. Table 54 describes the information that appears for SSIDs and
VLANs that are currently configured for the device group.