88 | Configuring and Using Device Groups
Dell PowerConnect W-AirWave 7.6 | User Guide
Figure 55
illustrates these components and this navigation:
Figure 55:
Groups > Cisco WLC Config > Security
Navigation Illustration
Configuring Management Settings for Cisco WLC
AirWave allows you to configure of SNMP and Syslog Server settings for Cisco WLC controllers. You can configure
up to four trap receivers on the Cisco WLC including the AMP IP that can be used in Global Groups. To define
SNMP and server settings, go to the
Groups > Cisco WLC Config > Management
page, illustrated in
Figure 56
.
Figure 56:
Groups > Cisco WLC Config > Management
Navigation Illustration
Configuring Group PTMP Settings
The
Groups > PTMP
configuration page configures Point-to-Multipoint (PTMP) for all subscriber and base
stations in the device group. Subscriber stations must be in the same group as all base stations with which they
might connect.
Perform the following steps to configure these functions.
1. Go to the
Groups > List
page and select the group for which to define PTMP settings by selecting the group
that supports Proxim MP.11. Alternatively, select
Add
from the
Groups > List
page to create a new group.
2. Select the
Groups > PTMP
tab.
Figure 57
illustrates this page.
Summary of Contents for PowerConnect W-AirWave 7.6
