Dell Force10 MXL Blade, Reference Manual

Page: 78 / 732

78 | Control and Monitoring
www.dell.com | support.dell.com
undebug all
Disable all debug operations on the system.
Syntax undebug all
Defaults
none
Command Modes
EXEC Privilege
Command
History
virtual-ip
Configure a virtual IP address for the active management interface. You can configure virtual
addresses for IPv4 independently.
Syntax virtual-ip
{
ipv4-address
}
Parameters
Defaults none
Command Modes CONFIGURATION
Command
History
Usage
Information
Each time this command is issued, it replaces the previously configured address of the same family.
The
no virtual-ip
command now takes an address/prefix-length argument, so that the desired address
only is removed. If you use the
no virtual-ip
command without any specified address, the IPv4 virtual
addresses are removed.
Example Figure 4-33. virtual ip (IPv4) Command Example
write
Copy the current configuration to either the startup-configuration file or the terminal.
Syntax write
{
memory
|
terminal
}
Parameters
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
{
ipv4-address
}
Enter the IPv4 address (A.B.C.D) of the active management interface.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#virtual-ip 10.11.197.99/16
memory
Enter the keyword
memory
to copy the current running configuration to the startup
configuration file. This command is similar to the
copy running-config startup-config
command.
terminal
Enter the keyword
terminal
to copy the current running configuration to the terminal. This
command is similar to the
show running-config
command.