[222] Homing OK
NOTICE
This option is available only with
software version 48.XX.
Homing is completed with the selected
homing function
[223] On Target
NOTICE
This option is available only with
software version 48.XX.
Positioning is completed and the on target
signal is sent when the actual position is
within
for the duration of
and the actual speed does not
exceed
parameter 3-05 On Reference Window
.
[224] Position Limit
NOTICE
This option is available only with
software version 48.XX.
The position error exceeds the value in
parameter
parameter 4-71 Maximum Position
for the time set in
parameter 4-72 Position Error Timeout
.
[225] Position Error
NOTICE
This option is available only with
software version 48.XX.
The position is outside the limits set in
parameter 3-06 Minimum Position
and
parameter 3-07 Maximum Position
[226] Touch on Target
NOTICE
This option is available only with
software version 48.XX.
Target position is reached in touch probe
position mode.
[227] Touch Activated
NOTICE
This option is available only with
software version 48.XX.
Touch probe positioning active. The
frequency converter monitors the touch
probe sensor input.
[231] In Power Lim.
Mot.
[232] In Power Lim.
Gen.
[233] In Power Limit
5-30 Terminal 27 Digital Output
Option:
Function:
[0] No operation Functions are described in
parameter group
5-3* Digital Outputs
.
5-31 Terminal 29 Digital Output
Option:
Function:
NOTICE
This parameter is applicable
for FC 302 only.
[0]
No operation
Functions are described in
parameter group 5-3* Digital
Outputs
.
[1]
Control Ready
[2]
Drive ready
[3]
Drive rdy/rem ctrl
[4]
Enable / no warning
[5]
Running
[6]
Running / no warning
[7]
Run in range/no warn
[8]
Run on ref/no warn
[9]
Alarm
[10]
Alarm or warning
[11]
At torque limit
[12]
Out of current range
[13]
Below current, low
[14]
Above current, high
[15]
Out of speed range
[16]
Below speed, low
[17]
Above speed, high
[18]
Out of feedb. range
[19]
Below feedback, low
[20]
Above feedback, high
[21]
Thermal warning
[22]
Ready,no thermal W
[23]
Remote,ready,no TW
[24]
Ready, Voltage OK
[25]
Reverse
[26]
Bus OK
[27]
Torque limit & stop
[28]
Brake, no brake war
[29]
Brake ready, no fault
[30]
Brake fault (IGBT)
[31]
Relay 123
[32]
Mech brake ctrl
[33]
Safe stop active
[35]
External Interlock
[38]
Motor feedback error
[39]
Tracking error
[40]
Out of ref range
[41]
Below reference, low
[42]
Above ref, high
[43]
Extended PID Limit
[45]
Bus ctrl.
[46]
Bus ctrl, 1 if timeout
[47]
Bus ctrl, 0 if timeout
[50]
On Reference
Parameter Descriptions
VLT
®
AutomationDrive FC 301/302
120
Danfoss A/S © 10/2018 All rights reserved.
MG33MP02
3
3
Summary of Contents for VLT AutomationDrive FC 302
Page 2: ......