5-32 Term X30/6 Digi Out (MCB 101)
Option:
Function:
[39]
Tracking error
[40]
Out of ref range
[41]
Below reference, low
[42]
Above ref, high
[43]
Extended PID Limit
[45]
Bus ctrl.
[46]
Bus ctrl, 1 if timeout
[47]
Bus ctrl, 0 if timeout
[50]
On Reference
[51]
MCO controlled
[54]
24V Encoder Sim
[55]
Pulse output
[60]
Comparator 0
[61]
Comparator 1
[62]
Comparator 2
[63]
Comparator 3
[64]
Comparator 4
[65]
Comparator 5
[70]
Logic rule 0
[71]
Logic rule 1
[72]
Logic rule 2
[73]
Logic rule 3
[74]
Logic rule 4
[75]
Logic rule 5
[80]
SL digital output A
[81]
SL digital output B
[82]
SL digital output C
[83]
SL digital output D
[84]
SL digital output E
[85]
SL digital output F
[90]
kWh counter pulse
Sends a pulse (200 ms pulse
width) to output terminal
whenever kWh counter changes
(
parameter 15-02 kWh Counter
).
[96]
Reverse After Ramp
NOTICE
This option is available only
with software version 48.XX.
[98]
Virtual Master Dir.
NOTICE
This option is available only
with software version 48.XX.
[120] Local ref active
[121] Remote ref active
[122] No alarm
[123] Start command activ
[124] Running reverse
[125] Drive in hand mode
[126] Drive in auto mode
[151] ATEX ETR cur. alarm
[152] ATEX ETR freq. alarm
5-32 Term X30/6 Digi Out (MCB 101)
Option:
Function:
[153] ATEX ETR cur. warning
[154] ATEX ETR freq. warning
[180] Clock Fault
[181] Prev. Maintenance
[188] AHF Capacitor Connect
[189] External Fan Control
[190] Safe Function active
[191] Safe Opt. Reset req.
[192] RS Flipflop 0
[193] RS Flipflop 1
[194] RS Flipflop 2
[195] RS Flipflop 3
[196] RS Flipflop 4
[197] RS Flipflop 5
[198] RS Flipflop 6
[199] RS Flipflop 7
[221] IGBT-cooling
Use this option for handling the
overcurrent trips. When the
frequency converter detects an
overcurrent condition, it shows
alarm 13, Overcurrent
and triggers
a reset. If the overcurrent
condition occurs the third time in
a row, the frequency converter
shows
alarm 13, Overcurrent
and
initiates a 3-minute delay before
the next reset.
[222] Homing OK
NOTICE
This option is available only
with software version 48.XX.
[223] On Target
NOTICE
This option is available only
with software version 48.XX.
[224] Position Limit
NOTICE
This option is available only
with software version 48.XX.
[225] Position Error
NOTICE
This option is available only
with software version 48.XX.
[226] Touch on Target
NOTICE
This option is available only
with software version 48.XX.
Parameter Descriptions
VLT
®
AutomationDrive FC 301/302
122
Danfoss A/S © 10/2018 All rights reserved.
MG33MP02
3
3
Summary of Contents for VLT AutomationDrive FC 302
Page 2: ......