Danfoss VLT AutomationDrive FC 302, Programming Manual, Page: 203 / 346

Failure Alarm Element in
parameter 14-90 F
ault Level
Off Warning Trip Trip Lock Trip with
delayed
reset
10 V low 1 1490.0 X D – – –
24 V low 47 1490.1 X – – D –
1.8 V supply low 48 1490.2 X – – D –
Voltage limit 64 1490.3 X D – – –
Ground fault during ramping 14 1490.4 – – D X –
Ground fault 2 during cont.
operation 45 1490.5 – – D X –
Torque limit 12 1490.6 X D – – –
Overcurrent 13 1490.7 – – X D –
Short circuit 16 1490.8 – – X D –
Heat sink temperature 29 1490.9 – – X D –
Heat sink sensor 39 1490.10 – – X D –
Control card temperature 65 1490.11 – – X D –
Power card temperature 69 1490.12 –
2)
X D –
Heat sink temperature
1)
244 1490.13 – – X D –
Heat sink sensor
1) 245 1490.14 – – X D –
Power card temperature 1)
247 1490.15 – – X D –
Motor phase missing 30–32 1490.16 – – X D –
Inverter overloaded 9 1490.18 – – – D –
Current limit 59 1490.19 – – – D –
Locked rotor 99 1490.20 – – D X –
AIC earth fault 407 1490.21 X X X D X
404 DC link voltage out of range 404 1490.22 X X X D X
300 mains contactor fault 300 1490.23 X X X D X
Table 3.27 Selection of Action when Selected Alarm Appears
MCT 10 Set-up Software has the element numbers listed in the column ID. Use this table together with MCT 10 Set-up Software to get information
about specific fault levels.
D stands for the default setting.
X stands for a possible option.
1) Only high-power frequency converters.
2) In small and medium power frequency converters, alarm 69, Power card temperature is only a warning.
Parameter Descriptions Programming Guide
MG33MP02 Danfoss A/S © 10/2018 All rights reserved. 201
3 3