E1200 HT 260-3
5BAssembly
23.04.07
00401010_41087
6-1
6
Assembly
The equipment may only be transported and set up by workers trained by centrotherm.
Improper arrangement can damage the equipment or impair the functioning of the
equipment.
Make sure that all assembly groups have been warmed up to indoor temperatures
before installation to prevent damages caused by condensation water.
6.1
Preparing the Installation Site
Check the installation site.
The admissible ambient temperature and relative humidity of air are listed in chapter
2.1.3.1 Ambient Air, page 2-3.
The place of installation must be dry and dust free.
Type, condition, and capacity of the factory floor must be rated for the assembly groups
and must be smooth and horizontal.
The factory floor must be marked dust-free by the customer. For equipment
dimensions, refer to the layout in chapter 12.2 Drawings, Circuit Diagrams, Overviews,
page 12-1.The alignment is done by setting the dimensions into relationship to each
other.
For documents to be used for assembly, refer to chapter 12.2 Drawings, Circuit
Diagrams, Overviews, page 12-1.
6.2
Equipment Check
The system was installed for the functioning test at centrotherm. The functions were
tested.
Open the packing, doors and casings carefully. Parts may have been damaged during
the transport. Subassemblies may have come loose and fall out.
When receiving the equipment on site, check the equipment for external damage.
Report any damages to the centrotherm service department.
centrotherm thermal solutions GmbH + Co.KG
Johannes-Schmid-Str. 8
89143 Blaubeuren
Germany
Phone: +49 7344 9186-600
eMail: [email protected]
Summary of Contents for E1200 HT 260-3
