CENTROTHERM E1200 HT 260-3, Operating Instructions Manual

Page: 120 / 233

E1200 HT 260-3
8BMaintenance
23.04.07
9-16
00401010_41087
9.2.7 ID 3251 – 3512 Error Messages CMS
Only stated ID No. are used.
ID No. Error message
text
Cause Troubleshooting
3261
3262
3263
3264 release temp.
reached stack enable message:
Process
temperature is
reached.
Operating mode not enabled:
Check if CMI temperature setting is
correct.
Check if CESAR control computer
temperature setting is correct.
Check thermocouple.
Check input module connection, see gas
and electrical circuit diagrams listed in
chapter 12.2 Drawings, Circuit Diagrams,
Overviews, page 12-1.
3270
3271
3272
3273
3278 short-circuit
heating spiral
stack Short circuit
detected at
heating spiral of
the heating
cassette of the
stack. De-energize heating cassette and check
if there is an electrical connection
between the heating cassette
connections and the silicon carbide tube.
If so, replace heating cassette.
Check faulty contact, see gas and
electrical circuit diagrams listed in
chapter 12.2 Drawings, Circuit Diagrams,
Overviews, page 12-1.
Check input module connection, see gas
and electrical circuit diagrams listed in
chapter 12.2 Drawings, Circuit Diagrams,
Overviews, page 12-1.
3274
3275
3276
3277
3279
disturbance
H
2
torch stack
Disturbance
detected at
hydrogen torch of
the stack. Check if mains switch of flaring unit is
switched on.
Check the fuses in the rack of the flaring
unit.
Check if glow plug 1 in the flaring unit has
burned out.
Check faulty contact, see gas and
electrical circuit diagrams listed in
chapter 12.2 Drawings, Circuit Diagrams,
Overviews, page 12-1.
Check input module connection, see gas
and electrical circuit diagrams listed in
chapter 12.2 Drawings, Circuit Diagrams,
Overviews, page 12-1.