Canon imageCLASS MF8450c, Service Manual

Page: 295 / 349

Chapter 16
16-14
Not used
<SYSTEM>
T-16-14
<HV-TR>
Not used
<CCD>
T-16-15
<PARAM>
T-16-16
T-16-17
T-16-18
COPIER > FUNCTION > SYSTEM
Sub item Description
DOWNLOAD Switching to the download mode
COPIER > FUNCTION > CCD
Sub item Description
DF-WLVL1 Not used
DF-WLVL2 Not used
COPIER > FUNCTION > PARAM
Sub item Description
SYS-SW Registration of system parameters (See the table shown below.)
PARAM > SYS-SW
SW Bit Function Remarks
05 7 Switching of whether or not to prohibit exporting of PWD in the address book (0: Do not prohibit
exporting, 1: Prohibit exporting) Initial value: 1
COPIER > FUNCTION > PARAM
Sub item Description
SYS-NUM 001 to 100
FAX-SW Not used
FAX-NUM Not used
NET-SW SW01 to SW50
NETNUM 001 to 050
NET-CERT VERSION CA certificate version
SRLNUM Serial number
SIGALG Signature algorithm
ISSUER Issuer
VLD_FROM Commencement date of the expiration period
VLD_TO Finishing date of the expiration period
SUBJECT Subject of issuance
PUB_KEY Public key algorithm and size
THMB_PRT Digest (Thumb imprint)
CDC-SW Not used
CDC-NUM Not used
EXC-NAVI Switch for whether or not to start up the installation navigation
When setting this switch to 1 after the installation navigation is completed, the installation navigation does not start up at the time
of next activation.
Setting value: 0: Start up the navigation. 1: Do not start up the navigation.
[Factory setting value/Value after RAM clearing: 0]
DSP-PPRSE Setting of whether or not to display the paper setting screen when ACS setting is set to ON at the time of copy operation
Setting value: 0: Do not display the screen. 1: Display the screen.
[Factory setting value/Value after RAM clearing: 0]
SET-PPRSZ Setting of the ACS document size when DSP-PPRSEL is set to ON
When the document size is unknown, a screen prompting an operator to enter the document size is displayed.
When the sizes other than UNKNOWN are specified, ACS judgment processing is performed based on the specified document
size.
Setting range: 0 to 20
Setting value: 0: UNKNOWN, 2: A4, 3: A5, 7: B5, 12: LGL, 13: LTR, 60: STMT
[Factory setting value/Value after RAM clearing: 0]
DSP-TNROW Setting of whether or not to display "Toner Low"
Setting value: 0: Do not display the screen. 1: Display the screen.
[Factory setting value/Value after RAM clearing: 1 (0 for iR C1022/iR C1022i (for US) only) ]
SCAN-SW Not used
SCAN-NUM Not used