Voicemail Pro Installation and Maintenance Guide
Page 66
Voicemail Pro Installation and Maintenance Guide
15-601063 Issue 15b (31 May 2006)
IP Office
Configure the Interchange VPIM Interface to Voicemail Pro
These steps follow the instructions in Avaya Interchange Release 5.4 Adding a VPIM System to Your
Network which should be referenced for greater detail on Interchange configuration steps and options.
1. Check that Interchange has available VPNM ports
From the Interchange Main Menu, select Customer/Service Administration > Feature
Options. Check that there are sufficient current entries for the Maximum Number of
Digital Nodes and VPNM ports.
2. Set the Interchange General Parameters.
From the Interchange Main Menu, select System Parameters > General Parameters.
Ensure that the VPNM Port Field is set to 25.
3. Identify the Avaya Voicemail Pro to the interchange system.
From the Interchange Main Menu, select Networking Administration > Remote
Machine Administration > VPIM Machine Administration.
Select the name of the machine by telnet to the SMTP port of the Voicemail Pro to see
how it identifies itself.
4. Set the IP Office parameters.
From the Interchange Main Menu, select Interchange Administration > Remote
Machine Administration > Remote Machine Parameters.
Select Choices. Select the Voicemail Pro name as the Remote Machine Name then
enter the values as shown.
Machine Type = VPIM
Avaya Interchange? = n
Mailbox ID Length = 5
Failed Msg. Notification Priority = n
Msg ID? = y
Send Message for Warning? = n
Select the Details key to enter the following details:
Subscriber Updates Type = dynamic
Voiced Names for Dynamic? = y
Use DNS? = n
Domain Name = Enter the domain name.
5. If the Voicemail Pro Dial Plan length is shorter than the Interchange Dial Plan, select
Interchange Administration > Remote Machine Administration > Dial Plan Mapping. Follow
the instructions in Avaya Interchange Release 5.4 Adding a VPIM System to Your Network to
map from the shorter length to the longer length dial plan.
6. Add the subscribers for Voicemail Pro. The following is one of several ways that this can be
done.
Select Interchange Administration > Remote Machine Administration > Dial Plan
Mapping.
Select the Voicemail Pro as the Remote Machine and then select Options.
Select Add Subscribers from range. Only mailboxes that are eligible to receive
messages should be included.
Subscriber entries can be checked from interchange Administration > Subscriber
Administration > Subscriber Lists > By Remote Machine Name. From Choices select
the Voicemail Pro PC name to see the list of known subscribers.
