AT&T MERLIN LEGEND Release 3.1, System Programming Manual

Page: 636 / 887

Remote Access Features
4–264
Programming Procedures
Remote Access Trunk Assignment
Use this procedure to assign or remove the trunks used for remote access. You
can also use this procedure to specify whether the Remote Access feature is
dedicated (always used for remote access) or shared (used for remote access
only when Night Service is activated).
Trunks used for dedicated remote access must not be assigned to ring into a
calling group or the QCC queue (Hybrid/PBX mode only).
In Hybrid/PBX mode, if a trunk assigned to ring into the QCC queue is also used
for shared remote access, perform the procedure below before you perform the
“QCC Operator to Receive Calls” procedure.
NOTE:
A loop start line/trunk must be programmed for Reliable Disconnect if it is to be
used for remote access (see “Disconnect Signaling Reliablility”).
Summary: Remote Access Trunk Assignment
Programmable by System manager
Mode All
Idle Condition Not required
Planning Form Form 3a, Incoming Trunks: Remote Access
Factory Setting Remote Access is not assigned
Valid Entries Dedicated, Shared, No Remote
Inspect Yes
Copy Option No
Console Procedure
LinesTrunks
®
RemoteAccss
®
LinesTrunks
®
Dial
line/trunk no.
®
Enter
®
Specify how trunk is used
®
Enter
®
Exit
®
Exit
PC Procedure
4
®
8
®
1
®
Type line/trunk no.
®
0
®
Specify how
trunk is used
®
0
®
5
®
5