AT&T MERLIN LEGEND Release 3.1, System Programming Manual

Page: 390 / 887

System Renumbering
4–18
Programming Procedures
Block Renumbering
Use this procedure to assign extension numbers to a group of extensions,
accessories, or lines. Both the original numbers and the numbers they are being
changed to must be sequentially numbered.
When required, this procedure should be performed immediately following the
selection of a system numbering plan.
See Chapter 3, “Common Administrative Procedures” for detailed information.
!
CAUTION:
Select
Exit
on the console or
5
on the PC when you have finished
renumbering extensions. If you press
Home
, extensions may remain in the
forced idle condition (indicated when the LED next to each DSS button is
on). To restore extensions to their normal operating state, restart the
system.
Summary: Block Renumbering
Programmable by System manager
Mode All
Idle Condition System idle
Planning Form Form 2a, System Numbering: Extension Jacks
Form 2b, System Numbering: Digital Adjuncts
Form 2d, System Numbering: Special Renumbers
Factory Setting Not applicable
Valid Entries Old and new extension numbers
Inspect Yes
Copy Option Yes
Console Procedure
SysRenumber
®
Block
®
Select type of group
®
Dial no. of
first group member
®
Enter
®
Dial no. of last group
member
®
Enter
®
Dial new beginning no.
®
Enter
®
Exit
®
Exit
®
Exit
PC Procedure
2
®
3
®
Select type of group
®
Type no. of first group
member
®
0
®
Type no. of last group member
®
0
®
Type new beginning no.
®
0
®
5
®
5
®
5
Direct Station Selector (DSS) Page Buttons
Use this procedure to set the three Page buttons on the DSS to correspond to
the system numbering plan. This procedure assigns extension numbers to DSS
buttons. You cannot program individual buttons on a DSS; this is the only
method for programming DSS buttons.