AT&T MERLIN LEGEND Release 3.1, System Programming Manual

Page: 388 / 887

System Renumbering
4–16
Programming Procedures
Procedure: Select System Numbering Plan
Console Display/Instructions Additional Information PC
1 Select the System Renumbering menu.
System Programming: >
Make a selection
System
Extensions
_
SysRenumber Options
Operator Tables
LinesTrunks AuxEquip
Exit NightSrvce
2
2 Select Default Numbering.
System:
If you get the System Busy message,
Make a selection
wait for an idle condition or exit system
_
Default Numbering
programming and try again later.
Single
Block
Exit
1
3 Select the appropriate system numbering plan.
Default Numbering:
Make a selection
_
2-Digit
_
3-Digit
Select
2-Digit 2-Digit
and go to Step 5.
1
_
SetUp Space
Select
3-Digit 3-Digit
and go to Step 5.
2
Select
SetUp Space SetUp Space
and continue with
3
Exit
Step 4.
4 Observe the initialize space screen.
Initialize Space:
AllExtensions 7000 range
If you selected
SetUp Space SetUp Space
you have finished this procedure.
Select
Exit Exit
and go to Step 6.
5
_
Exit
5 Select the type of extension to renumber.
System Renumber:
To change individual extension numbers,
Make a selection
select
Single Single
and go to “Single
Default Numbering
Renumbering.”
2
_
Single
_
Block
To change a block of extension numbers,
select
Block Block
and go to “Block
Exit
Renumbering.”
3