AT&T MERLIN LEGEND Release 3.1, System Programming Manual

Page: 640 / 887

Remote Access Features
4–268
Programming Procedures
Remote Access Without Barrier Codes
Use this procedure to change the class of restriction for one of the following:
■
All non-tie lines/trunks
■
All tie trunks and DID trunks with Remote Access
■
DID remote access code
!
Security Alert:
Your system will be highly susceptible to toll fraud if you activate the
Remote Access feature without barrier codes. AT&T does not recommend
doing this.
NOTE:
If barrier code requirements have been established for remote access users,
use “Remote Access with Barrier Codes” and not this procedure.
The class of restriction assigned may be one of the following:
■
Restriction. Determines whether remote access users can make local
and/or toll calls and includes the following settings:
Unrestricted
Toll restricted
Outward restricted
■
ARS Facility Restriction Level (Hybrid/PBX only). Allows or disallows
use of outgoing trunks by assigning a facility restriction level from 0
through 6. The FRL ranges from 0 (most restrictive) to 6 (least restrictive).
The FRL value assigned here is the opposite of the FRL value assigned to
the ARS route, where a value of 0 is the least restrictive and a value of 6 is
the most restrictive.
■ Allowed Lists Assignment. Assigns Allowed Lists and is used when
remote access users are restricted from making local or toll calls.
■
Disallowed Lists Assignment. Assigns Disallowed Lists and is used
when remote access users are not restricted from making local or toll
calls.
A maximum of eight Allowed or Disallowed Lists can be assigned to lines/trunks.
Class of restriction settings are assigned either to all non-tie trunks or to all tie
trunks and DID trunks. They cannot be assigned to each trunk on an individual
basis.