AT&T MERLIN LEGEND Release 3.1, System Programming Manual

Page: 159 / 887

System Operator Positions
Common Administrative Procedures
3–23
Console Display/Instructions Additional Information PC
4 Specify the QCC extension.
QCC Operator Positions:
If no DSS is attached:
Enter extension
SP: “Entering an Extension”
Û
If DSS is attached:
Store All Delete
Toggle the red LED on or
Backspace
off as required. Go to Step 6.
Exit Enter
On = extension is currently assigned
as a QCC position.
Flashing = extension can be assigned
as a QCC position.
Off = extension cannot be assigned
as a QCC position.
5 Assign or remove the QCC operator extension.
Select
Enter Enter
or
0
Delete Delete
.
8
You may continue to assign or remove
QCC operator positions by repeating
Steps 4 and 5.
6 Indicate that you have finished entering all positions.
Select
Store All Store All
.
3
The session is terminated and the system
restarts. You must enter system
programming again to continue.
DLC Operator Positions
DLC operator positions can be assigned to the first and fifth extension jacks on
the first modules with digital or analog multiline extension jacks. A maximum of
eight DLC operator positions can be assigned. Any combination of operator
positions can be assigned as long as there are no more than four QCC operator
positions and no more than a total of eight operator positions.
Use this procedure to specify extensions that serve as central answering
positions for all incoming calls, for Call Management Systems (CMSs) connected
to operator extension jacks, or as calling group supervisor extensions. (You do
not need to use this procedure in a Key or Behind Switch system unless you
have more than one DLC position.) For a new system, remove the factory-set
DLC operator position assignment for any telephone not used as an operator
position.
Lines and trunks are assigned on individual buttons.