AT&T MERLIN LEGEND Release 3.1, System Programming Manual

Page: 424 / 887

Lines and Trunks
4–52
Programming Procedures
The LS-ID Delay setting appears on the Ground-Start/Loop-Start Trunk
Information report.
Any extension or adjunct that answers an incoming CO line on the first ring
causes the Caller ID information associated with the call to be lost. The adjunct
must be programmed to either answer the call on the second (or later) ring, or
the call must be delayed. The call can be delayed by setting the ring option on
the buttons associated with the adjunct or by using the LS-ID Delay option.
NOTE:
Caller-ID information is not available on ground-start lines/trunks.
Summary: Loop-Start Identification Delay
Programmable by System manager
Mode All
Idle Condition Not required
Planning Form Form 2c, System Numbering: Line/Trunk Jacks
Factory Setting No delay
Valid Entries Loop-start line/trunk numbers
Inspect Yes
Copy Option Yes, but only to the same trunk type
Console Procedure To program a single line/trunk:
LinesTrunks
®
More
®
LS-ID Delay
®
Select entry mode
®
Dial no. of the line/trunk
®
Enter
®
Exit
®
Exit
To program a block of lines/trunks:
LinesTrunks
®
More
®
LS-ID Delay
®
Select block of
lines/trunks
®
Toggle LED On/Off
®
Enter
®
Exit
®
Exit
PC Procedure To program a single line/trunk:
4
®
u
®
6
®
6
®
Type no. of the line/trunk
®
0
®
5
®
5
To program a block of lines/trunks:
4
®
u
®
6
®
Select block of lines/trunks
®
Toggle
letter
G
On/Off
®
0
®
5
®
5